Why damp matters for health
In 2009 the World Health Organization published its first guidelines on indoor air, on dampness and mould. After reviewing more than 100 studies, it concluded that there is strong evidence that damp homes are a risk to health, and that preventing or fixing damp and mould significantly reduces the harm.
The evidence links damp and mould to coughing, wheezing, respiratory infections, and both the development and the worsening of asthma. A widely cited analysis estimated that damp or mould in a home is associated with roughly 30 to 50% increases in a range of respiratory and asthma-related problems.
The WHO also noted that in many European countries, 20 to 30% of households have problems with damp.
The humidity sweet spot
Relative humidity (RH) is how much moisture the air holds compared with the most it could hold at that temperature. An inexpensive digital hygrometer will show it.
- Under 30%Dry air. Wood floors and furniture shrink.
- 30 to 40%Acceptable, especially in cold weather.
- 40 to 60%The practical range to aim for.
- Over 60% for long spellsCondensation, mould and dust mites.
For most homes, 40 to 60% is a practical target. Below about 30%, air feels dry, and wood floors and furniture shrink. When readings stay above 60% for long periods, condensation forms on cold surfaces, mould can grow, and dust mites thrive.
No single reading guarantees a dry home, though. A cold external wall or window can run with condensation while the middle of the room reads 55%. That's why insulation, heating and ventilation work together.
Four kinds of damp, four different cures
| Type | What you see | Usual cause | The fix |
|---|---|---|---|
| Condensation | Mould in corners, behind furniture and on window reveals; streaming windows | Moist air meeting cold surfaces, with too little ventilation | Extraction, background ventilation, insulation and even heating |
| Penetrating damp | Damp patches on outside walls that grow after rain | Gutters, pointing, render, roofs or window seals letting water in | Repair the outside first, then let the wall dry out |
| Rising damp | A tide mark low on ground-floor walls, salts, crumbling plaster | A missing or bridged damp-proof course, often from raised ground outside | Remove whatever bridges it, lower outside ground levels, specialist repair where needed |
| Leaks | Stains below bathrooms and kitchens, swollen floors, a musty smell | Failed seals, pipework or waterproofing | Fix the leak, renew failed seals or tanking, and dry out before refinishing |
Condensation is the most common cause of mould in homes, and usually the easiest to fix. Mould that keeps coming back after cleaning means the cause hasn't been dealt with.
Ventilation: the rules and the reasons
Every shower, kettle and pot on the hob puts moisture into the air. Extraction removes it at the source, before it can settle on cold walls. Irish Building Regulations guidance (TGD F) sets minimum rates for intermittent extract fans:
| Room | Minimum rate |
|---|---|
| Kitchen, extract next to the hob (such as a cooker hood venting outside) | 30 litres a second |
| Kitchen, extract elsewhere in the room | 60 litres a second |
| Utility room | 30 litres a second |
| Bathroom or shower room | 15 litres a second |
| Toilet | 6 litres a second |
Fans only work if they're used and maintained. A fan with a run-on timer or a humidity sensor keeps working after you leave the room. Trickle vents in windows should stay open, and air bricks outside shouldn't be blocked.
Damp, floors and finishes
Moisture is the main enemy of new floors and finishes. These are the rules we work by:
- Test before laying wood. Wood flooring guidance asks for screeds below 75% relative humidity for floating floors and 65% for glued ones. A new screed can take months to dry.
- Keep suspended timber floors ventilated. Air bricks let moisture escape from under older floors; blocking them invites rot.
- Waterproof wet areas. Showers need a waterproof membrane behind the tiles. Grout alone won't keep water out.
- Let old walls breathe. Solid walls in older homes need breathable finishes. Sealing them in can trap moisture.
- Leave air behind built-ins. Wardrobes against cold external walls need a gap behind them, or mould grows where you can't see it.
Radon: the one you can't see
Radon is a natural radioactive gas that rises from the ground. You can't see, smell or taste it. It's linked to around 350 cases of lung cancer in Ireland each year, and the average radon level in Irish homes, 77 Bq/m³, is about twice the European average.
The reference level for homes is 200 Bq/m³; above it, the EPA advises reducing the level. Areas where 10% or more of homes are expected to exceed it are called High Radon Areas, and you can check yours on the EPA's radon map by Eircode. Homes outside those areas can still have high levels, so the only way to know is to test, over at least three months.
The risk builds over a lifetime and is far higher for smokers. The EPA estimates that a lifetime at the reference level carries an average lung cancer risk of about 1 in 50, and about 1 in 700 for non-smokers.
Where renovation helps: new homes in High Radon Areas must have a radon barrier and a standby sump. If you're taking up a ground floor or building an extension, that's the easiest time to add the same protection. Test again once the work is done.
Questions
- Is mould on walls a health risk?
- Mould growing indoors is a sign of too much moisture, and the WHO links damp and mould to respiratory problems and asthma. Clean small patches, but fix the cause, or it will come back.
- Will a dehumidifier fix damp?
- It helps with condensation and drying a room out, but it won't fix leaks, penetrating damp or rising damp. Find the source first.
- Do extractor fans really make a difference?
- Yes, if they're sized and used properly. Irish guidance sets minimum rates, and a fan that runs on after you leave clears far more moisture than one that stops with the light.
- How do I test for radon?
- Use a radon testing service, which sends detectors to place in your home for at least three months. Only a test of that length can be compared with the reference level.
Sources
- WHO Europe: First indoor air quality guidelines, on dampness and mould (2009)who.int
- WHO Guidelines for Indoor Air Quality: Dampness and Mouldncbi.nlm.nih.gov
- Cox-Ganser: Indoor dampness and mould health effects (European Respiratory Journal)pmc.ncbi.nlm.nih.gov
- Sahakian et al.: Dampness and mould in the indoor environment (CDC Stacks)stacks.cdc.gov
- Guinness Homes: What should the humidity be in a house?guinnesshomes.co.uk
- BRANZ: Dealing with internal moisturebranz.co.nz
- Tipperary County Council: Ventilation in dwellings, a review of TGD F 2019tipperarycoco.com
- Electrical Wholesaler: Extractor fan rates under Part Felectricalwholesaler.ie
- Wood Flooring Association: engineered design glued installation guidelineswfa.uk.net
- EPA: radon advice for householdersepa.ie
- EPA: Radon in homes (2024)epa.ie
- EPA: Radon and your health (July 2025)epa.ie
- EPA: Radon measurement servicesepa.ie
- TheJournal.ie: 170,000 homes thought to be at risk from radonjrnl.ie
This guide is general information, not legal, financial or professional advice. Grant amounts, rules and regulations change, so check the sources above or ask a qualified professional before you rely on them. Last reviewed 19 November 2026.